Product - Mr. JO Tecbond-NSF

Description

Two component thick solvent free non sag epoxy system suitable for outdoor/indoor wood furniture and fixtures. It provide better dimensional stability to furniture/fixture for longer term.

• Color: White
• Pot life @25°C: 45-60 mins
• Mixing Ratio: 100:100 PBW
• Mixture consistency: Putty paste
• Optics: Opaque
• Suitable for synthetic wood
• Non drip(up to 5mm) on overhead/vertical surface

• Synthetic wood to laminates
• Synthetic wood to veneer
• Bonding dissimilar materials like wood to metal, wood to concrete etc.
• Outdoor wood furnitures/fixtures

• The mixture should be applied on a clean, rough and dry surface. For good results, it is required that the concrete surface is clean, rough and dry. This should be achieved by suitable mechanical and chemical means such as sandblasting. Wire brushing or chemical etching. Suitable degreasing agent should be used to remove any grease, oil or traces on the surface.

• Use Part A & Part B in ratio 100:100 PBW. Mix the two components in small batches thoroughly for at least 2 minutes
• Apply the mix on the prepared substrate directly or using proper spatula.
• Sufficient quantity of adhesive is to be applied so that bonding layer between the substrate is sufficient thick.
• Allow at least 8 hours for good bond strength.

General Inquiries

There are no inquiries yet.